Foot-It-N Beta 0.3

Instructions

  1. Start the application you want to drive with Foot-It-N and set it to full screen
  2. Start Foot-it-N and arrange the window on the screen (place it in a point where it doesn't cover any useful button)
  3. Click on "MIDI config" to select your MIDI input device. Your choice will be saved for next uses.
  4. Click on "Key Assign" to configure your MIDI actions
  5. Click on "New"
  6. Give a name for your actions' collection (next time you can recall the one you want from the list. Foot-It-N will automatically load the last collection you used last time)
  7. Select the new collection on the "file" box to edit it
  8. Click on "Assign new key"
  9. Give a name for the action
  10. Send a MIDI command (keyboard note, foot control, etc)
  11. If all is right click on "Confirm" else click on "Repeat" and send another command
  12. Confirm again
  13. Click on the button (in the application you want to drive) you want to assign to the MIDI command
  14. Repeat this steps for all the actions you want to assign
  15. NEXT and PREVIOUS actions are programmed in a similar way. With this actions you can drive MIDI commands that acts in a sequence in forward or reverse mode.
  16. The SEQUENCE box contains a list of actions that you can define in a sequence clicking on ">" "<<" ">>" and ">" buttons.
  17. You can change the sequence order with "Up" and "Down" buttons
  18. Press OK to save all the data
  19. Now that you defined your actions and sequence you can start the program with the "START" key (when you will open Foot-It-N next time it will remember the last MIDI device and collection you used)
  20. The blue box starts blinking telling you that Foot-It-N is waiting for a command
  21. Send someone of the MIDI commands you defined and the program will click the corresponding application button
  22. If you use the NEXT and PREVIOUS assigned MIDI controls you will activate the actions you defined step by step in sequence (forward or reverse)


Return to the main page .